HyperV|W2k12R2|3x1GB

Done use that configuration in production! It’s only for lab use!

This configuration is very similar to the 4x 10Gb Ethernet config but not useable for production.

Hyper-V Cluster Network configuration with following parameters:

The following configuration leverages 3x 1GB Ethernet NICs and LOM (LAN on Motherboard). The storage can be connected via iSCSI with MPIO or SMB 3.x.x without RDMA. The configurations uses physical configuration and software defined / converged network for Hyper-V.


 Pro’s and Con’s of that solution

 Pro Con
– Easy to build and good for lab use
– enougth bandwidth for test workloads
– fully converged
– limited bandwidth
– no production use
– cheap to build

 Switches

1GBE SW01 1 GBit/s physical stacked or independed
1GBE SW02 1 GBit/s physical stacked or independed
SoftSW01 1 GBit/s Software defined / converged

 Neccessary Networks

Networkname VLAN IP Network (IPv4) Connected to Switch
Management 100 10.11.100.0/24 SoftSW01
Cluster 101 10.11.101.0/24  SoftSW01
Livemigration 450 10.11.45.0/24 SoftSW01
Storage 400 10.11.40.0/24 SoftSW01
Virtual Machines 200 – x 10.11.x.x/x SoftSW01

 Possible rearview Server


 Schematic representation


Switch Port Configuration


Bandwidth Configuration vNICs

vNIC min. Bandwidth Weight PowerShell Command
Management 10%
Cluster 5%
iSCSI 30%
Livemigration 30%

QoS Configuration Switch

Networkname Priority
Management medium
Cluster high
Storage high
Livemigration medium
VMs dependig on VM Workload